Sterling Silver Ring Clip Size Adjuster/ Reducer
All Rings must be large enough to fit over the knuckle, but then often tend to be TOO large to sit upright on the finger.
Stones can make a ring top heavy, and they tend to "roll" or "spin" so the stones are not shown properly (often ending up on the palm side of your hand).
If your ring is too loose after passing your knuckle this "ring spinning" is even greater.
Sometimes spinning right OFF your finger. Ring Clips solve that problem.
Once your ring clip is on, your ring is sized. You can now wear your cherished ring in confidence.
The mm size shown is the width of the body X the width of the claw.
The ring clip does not have to match the width of the shank as long as the claw is long enough to grip the shank securely.
- One piece of Ring Clip
- 100% solid Sterling silver
- Option of different sizes
- Strong and high quality
- Easy to use
- FREE postage within the UK
In order to determine which size ring clip you require, you need to
measure the width at the back of the ring shank. The measurement you obtain
will determine the size, e.g. if the width of the ring you measured is 3mm,
then you need a ring clip size 3x7mm (the first number on the ring clip size
indicates the width of the ring and the second number indicates the length of
claw which goes around the ring in order to attach it to the ring).
Please note that ring clip can reduce the ring size up to two UK
sizes maximum.