Charcoal Block

Charcoal Block used to solder on.  charcoal block, it is good at absorbing oxygen during soldering to prevent firestain. Also it is soft allowing you to make dips in the charcoal block to make small round balls of silver. It also protects your surface from the heat of the flame torch. Some people tie iron wire binding around the charcoal block to stop it breaking over long use.

Also you can buy metalbase in order to stop your charcoal block falling part, it is metal tray that fits the large charcoal block perfectly.

Available in Large and Small

Charcoal Cylinder Block

Charcoal Cylinder Block used to solder on. This is hard pressed charcoal cylinder block. More harder than the natural soft block above. It also protects your surface from the heat of the flame torch. Some people tie iron wire binding around the charcoal block to stop it breaking over long use.

Available:

Large Charcoal Block (Natural) - Size: 140 mm x 70 mm x 30mm

Small Charcoal Block (Natural) - Size: 80 mm x 60 mm x 30mm

Large Charcoal Block (Natural) with metal base

Charcoal Cylinder Block (Hard pressed) - 150mm diameter

Metal Base - 140mm x 70mm