This is your ONE-STOP SHOPPING for all sizes and styles!
SIZING:
Steering wheels (most models 05-14, but measure to confirm) = 2.375in size
Rear deck lid emblem 2005-2009 = 2.875in size
Rear deck lid emblem 2010-2014 = 4.1in size
IMPORTANT: The factory deck lid emblems and steering wheel emblems for 2010-2014 have significantly RAISED areas and we recommend that you grind this down before installation ("Dremel" tool works best)!
If your emblem overlays aren't DOMED, they are just flat "stickers"
that will not last! Domed overlays are extremely durable and will
hold up to the harsh outdoor environment that they are subjected to!
With proper installation, expect them to last at least 5yrs!
These domed emblem overlays look great on just about ANY
smooth surface!. Please be sure they will fit your vehicle before buying!
Any questions, please ask!
These are domed, flexible, vinyl *OVERLAYS* that are designed to
install over your factory Ford emblems- the factory emblems are
NOT included- sorry!
Why buy FLAT, cheap "stickers" for your ride when you can have
DOMED!? "Domed" (or
"gel-coated") decals are THICK, UV stable, polyurethane coated decals
that will last
for years without turning yellow (like epoxy does) or cracking! MUCH
more durable than your typical "flat" decal, too- you will be amazed at
the difference!
These are thermally printed on the best vinyl in the vehicle wrap
industry (3M™ Controltac™ Plus Graphic Film
with Comply™ Performance) and then gel-coated ("domed") with clear
polyurethane for durability and high quality
OEM look!
Don't be fooled when a seller states they are using "high
quality outdoor durable vinyl", etc..yes, it may considered "outdoor
vinyl", but in reality it may be "intermediate vinyl" (CHEAP vinyl). It will
shrink and crack long before "cast" outdoor vinyl will! BUYER BEWARE!
How hard are these to install? Not hard at ALL! Why? Because this
very high-tech, specialty vinyl allows you to
position the overlay and then lift it back up if you need to- again and
again and again until you apply pressure and
make it "permanent"! Install them DRY with no worries!! When you
want to remove it- simply heat it up (hair dryer
works fine if you do not have a heat gun) and peel it off. AND it's
removable up to 4yrs without leaving any residue or
adhesive behind!
From the manufacturer:
"Durable, dimensionally stable, vinyl film with positionable,
pressure activated adhesive (permanent, changeable
or removable) that allows it to be repositioned on the application surface
during installation. Special channels allow
trapped air to escape, which reduces air bubbles that typically occur as
large format graphics.
We don't just throw
these decals in an envelope and slap a $.49 stamp on them!! They will
be sandwiched between two layers of thick Coroplast®- these babies
won't show up damaged!!