Reconditioning a Lead Acid Battery

Desulfation (also know as Reconditioning or electrolyte stratification) offers a way for dead batteries to be brought back to life and for tired batteries to be rejuvenated. Desulfation will not bring batteries with a shorted cell, or worn out plates back to their former glory, but it is a valuable tool for anyone depending on battery storage for power who cannot afford to buy new batteries.

When lead sulphate crystals build up on the lead plates, it is not an easy task to remove them and thereby recondition the battery. As more and more crystallisation occurs, the voltage required to shift the crystals (dissolving them back into the electrolyte) also increases. But, if you were to put a constant high voltage through the battery it would overheat and could potentially explode. Pulse conditioning is therefore used to ensure that only the sulphate crystals are affected and the battery does not overheat.

+YOU CAN call it  IT A BATTERY DOCTOR TOO+

NOTE:  not every battery can be save....you may need to do you own research. Buyer should have some electronics background..

- it can be connected full time on your car battery or any 12 volts system.

- the process can takes up to 3 weeks

- for more info you can do research on the web.

INPUT VOLTAGE                       12Vdc

OUTPUT VOLTAGE                   30V (pk-pk)

RATED CURRENT                     40mA Average  nominal 12Vdc input.

FREQUENCY RANGE               1.50 KHz.

 

“This device has two leads, one red, one blue.  The battery should be connected to its charger in the usual manner.  The red lead from this device should be attached to the positive charger/battery connection, and the black lead from this device should be attached to the negative charger/battery connection.  This is what is called connecting the device in parallel with the charger” 

INSTRUCTION

 

1.) The desulfator should be installed as close as possible to the battery terminals. (within 14 inches, or 35 cm)

2.) You may trim the wire leads with wire cutters/strippers to work best for your application. (shorter is better) 

3.) Install the Red wire to the positive (+) terminal on your 12 volt battery.

4.) Install the blue wire to the negative(-) terminal on your 12 volt battery.

5.) Verify that the LED is on, you might also be able to hear a “buzzing” noise.

6.) The best results for recovery will occur within the first 4 weeks. If left connected longer, desulfating will continue but at a slower pace.

Shipping

· We Ship to Worldwide,

· Items will be shipped within 3  business day on payment received.

· Items are shipped from China using  Airmail, reach most of the countries  within 10 to 30 business days.

· Delivery time depends on destination  and other factors, it may takes up  to 50 business days.

 

 

 

 

 

THANK YOU !