To find the size you need. simply measure the BLUE area of your
factory grill and tailgate/rear hatch/trunk emblems. It is important to
confirm the size you need, especially if you purchased your vehicle
used, as sometimes the previous owner has swapped out the emblems,
grills or entire tailgates for one from a different year. See below info for
help in sizing:
Steering wheels (most ALL years/models, but measure to confirm) = .875in x 2.25in
-1999-2004 Super Duty GRILL emblems = 2.375in x 6.3in
-2005-2010 Super Duty GRILL emblems = 3.2in x 8.2in
-2011-2016 Super Duty GRILL emblems = 4.56in x 12in
-1999-2004 Super Duty TAILGATE emblems = 2in x 5in
-2005-2016 Super Duty TAILGATE emblems = 3.2in x 8.2in
**NOTE: if your vehicle has the factory back-up camera inside the
rear emblem, you will need a 2.375in x 6.3in size overlay. Measure to
confirm!**
-2006-2014 F-150 GRILL and TAILGATE emblems = 3.2in x 8.2in
**NOTE: if your vehicle has the factory back-up camera inside the
rear emblem, you will need a 2.375in x 6.3in size overlay. Measure to
confirm!**
-2015+ F-150 GRILL and TAILGATE (except Platinum) emblems = 3.312in x 8.625in
**NOTE: Your 2015+ F-150 Platinum, Limited & King Ranch editions will require a 1.75in x 4.625in tailgate emblem overlay. ALWAYS measure to confirm!**
-2017+ Super Duty GRILL and TAILGATE emblems = 4.125in x 10.875in
**NOTE: Your 2017+ Super Duty Platinum, Limited & King Ranch editions will require a 1.75in x 4.625in tailgate emblem overlay. Measure to confirm!**
The sizes in the drop-down menus may fit many other models as
well...just measure the BLUE area to find out!
These domed emblem overlays look great on just about ANY
smooth surface!. Please be sure they will fit your vehicle before buying!
Any questions, please ask!
These are domed, flexible, vinyl *OVERLAYS* that are designed to
install over your factory Ford emblems- the factory emblems are
NOT included- sorry!
Why buy FLAT, cheap "stickers" for your ride when you can have
DOMED!? "Domed" (or
"gel-coated") decals are THICK, UV stable, polyurethane coated decals
that will last
for years without turning yellow (like epoxy does) or cracking! MUCH
more durable than your typical "flat" decal, too- you will be amazed at
the difference!
These are thermally printed on the best vinyl in the vehicle wrap
industry (3M™ Controltac™ Plus Graphic Film
with Comply™ Performance) and then gel-coated ("domed") with clear
polyurethane for durability and high quality
OEM look!
How hard are these to install? Not hard at ALL! Why? Because this
very high-tech, specialty vinyl allows you to
position the overlay and then lift it back up if you need to- again and
again and again until you apply pressure and
make it "permanent"! Install them DRY with no worries!! When you
want to remove it- simply heat it up (hair dryer
works fine if you do not have a heat gun) and peel it off. AND it's
removable up to 4yrs without leaving any residue or
adhesive behind!
From the manufacturer:
"Durable, dimensionally stable, vinyl film with positionable,
pressure activated adhesive (permanent, changeable
or removable) that allows it to be repositioned on the application surface
during installation. Special channels allow
trapped air to escape, which reduces air bubbles that typically occur as
large format graphics are installed."
We don't just throw
these decals in an envelope and slap a stamp on them!! They will
be sandwiched between two layers of thick Coroplast®- these babies
won't show up damaged!!