Used to cut wire and tubes

Cutting length: 60mm

Width of tube:9mm

Also can cut Diagonally in 45 degree

This chenier cutter allows for a given length of tube to be cut many times, the tube stop can be adjusted to the required length. Made from metal with a plastic coated handle.

To operate:

Adjust the tube stop to the length required. Raise the lever and pass the tube along the 'V' until it reaches the tube stop. The point at which the tube is to be cut should be in line with the gap. Allow the lever to rest on the tube and secure with your thumb. Using the gap as a guide for the blade, cut the tube.

Used by jewellers, watch makers and hobbist