3D LED Printer Direct Wire Pi Controlled PWM 12v / 24v Strip Lighting KIT Description 3D LED Printer Direct Wire Pi Controlled PWM 12v / 24v Strip Lighting KIT Here we have a great kit for smaller printers. Often printing late at night or using Octopi to control a printer in the closet. Then this is for you :) This kit assumes you have some knowledge of working with your printer and a controller with controlled GPIO ports. Designed for the Creality CR-20 Printer but will work on almost any printer. This kit requires a controller to switch and does not include a manual switch. Includes 1x 12v LED Light Strip (33cm) 1x 12 / 24v Controllers Power Supply / Converter 3D Printed Mounts and end cap Mounting Hardware & Fixings Connect the bare wires to the power supply output and plug the power wire into the strip light. Connect the single control wire into a controller (3.3v, 5v & 12v) and off you go. This will switch the 12v output on when the control signal goes low Works with Raspberry Pi, Octoprint, Arduino or basically any controller & software that allows control of the GPIO pins. This will allow PWM dimming control of the light strip :) The 3D Printed PSU Case has mounting tabs and fixings designed to mount on the rails of most 3D printers. We have ours fixed on the under or internal support rails along with our octopi. 28cm power supply wire, 80cm LED power wire and 70cm control wire. All items are tested, security marked & photographed before dispatch From a non smoking and pet free household. Pictures are of the actual item(s) you will receive unless otherwise stated •POSTAGE/COMBINED POSTAGE/POSTAGE ABROAD• Please note we will post items anywhere fully insured/tracked. We will not post anything unrecorded or tracked for obvious reasons. There will be extra charges for postage abroad which we are unaware of until actual posting. We will normally charge a rough price for postage and then refund any extra after we take off the actual cost of packaging and postage. As we currently receive a huge amount of mails, any regarding postage covered here may go unanswered. We are happy to combine postage on items which again we cannot accurately judge until we have posted the items. In this case we will charge what we think it will cost and refund any difference upon posting. •RETURNS• All items are photographed and marked before posting. We will accept returns in certain circumstances but please contact us first with any issues you may have. •PAYMENT• If posting we prefer payment by Paypal. Payment by cheque, postal order, cash or bank transfer are also accepted at the buyers risk. If you prefer to collect the item then this can be arranged and must be cash on collection. If you have any questions please do not hesitate to ask