Super Kit containing everything you need for a wet end overhaul including brass shaft and oil end gaskets! Kit contains:
1 Brass shaft to suit METRIC thread BOTH ENDS
2 stainless steel METRIC nuts to suit, One lock nut the other standard
4 METRIC brass valve screws
1 centre brass washer for buckets (about 3mm thick)
2 Bucket brass washers (over 3mm thick)
4 Valve copper washers- Repurposed Australian 1 penny coins (better than the original)
4 Stainless springs
4 moulded valve rubbers
1 Head gasket (improved design - wider where it counts)
1 Gland gasket
2 side valve gaskets
1 cylinder end gasket
1 40cm length of packing -graphite impregnated teflon
4 oil proof paper gaskets (oil side)
1 valve to use as shaft rubber/ water separator
1 parts list / exploded diagram
1 rolled pin
Posts Australia wide
NB!!! THIS IS FOR A METRIC PUMP
CONTACT ME IF YOU ARE NOT SURE
Leave me feedback and I will return the favour
NB unless you specifically ask for the leathers with the 5/8" centre hole I will supply the 3/8" centre hole
To inspect please contact me through ebay