HHO Hydrogen Kit Complete
Dry Cell with 19 plates in stainless steel version available
Engines < span class = "notranslate" > </span> < 2400 cm3

Our generators are manufactured in the European Union, in accordance with the technical standards of industrial production of these products.

Dati tecnici

-Generator type: dry cell;

-Generator dimensions: 110x110x150 mm;

-Food: 19;

-Voltage: 12V;

-Standard electric connections of the cell:

+ NNNNN NNNNN NNNNN-+-(N-neutral plate);

-Production of hydrogen: < span class = notranslate ' > </span> 2.0 litres per minute (25A);

-Power supply: 12-15A.

Kit components:

The kit comes complete with all accessories required for installation:

-HHO Generator-Dry Cell with 19 plates in stainless steel version available;

-Polypropylene Tank (volume < span class = notranslate ' > </span> 1.2 liters) with level controls touch‑sensitive controls are located;

-High pressure hose for HHO gas;

-Monitoring relay 30A-12V DC;

-Electrical cables 6 mm-K section piping recommended for the electrical connections;

-Fuse and fuse holder 30A;

-Nylon safety check valve;

-Insulated terminals and accessories for all electrical connections;

-High pressure hose for HHO gas;

-Flexible PVC pipe for the electrolyte;

-Connectors and Sockets for connections;

-Electrolyte-potassium hydroxide (KOH);

-Extender for the lambda sensor (for cars with electronic fuel injection);

-Bubbler;

- Installation manual in Italian (Ebook Download);

Strengths of our products:

Size Generators -The small size of our generators allow an easy installation in all cars. The dry cell can also be installed horizontally or vertically, allowing greater flexibility for installation.

HHO gas production -Despite its performance, the cell size is relatively small in proportion to the amount of gas produced, which guarantees reliable operation over time. Easy reconfiguration of the dishes (plus, minus, neutral), by a system of terminals, allows better optimization according to your needs.

STAINLESS Plates -our plates are made of stainless steel 316 L, laser cutting, with a special chemical and physical treatment developed by our team to extend the service life of the generator. You won't see Brown deposits in our cells. A certificate from the manufacturer guarantees the quality and durability of stainless steel that is used.

Flanges-flanges new nylon was developed exclusively for use with our generators. Good physical stamina and above all, of thermal resistance (melting point 190-350° C) makes choosing the best nylon material for these products. Since the generator will be installed in the engine compartment, where the temperatures in summer can be very high, the thermal resistance of the materials used is very important.

Gaskets and seals -Special elastomers EPDM (temperature range: from-40 to 200° C), with a square cross section and large contact surface. The optimal distribution of pressure across the surface.

Summary of the strengths of our products

-High quality materials guarantee a long life product;

-easy Reconfiguration of slab (positive, negative and neutral) by a system of terminals, to optimize the performance of your system;

-No deposits dry cell and electrolytes in the Brown circuit;

-Stable operating temperature of the generator without risk of overheating

-cell Insulation to withstand extreme cold in winter conditions, in order to continue to be effective in even the most extreme conditions.