Simply place the ribbon on the connector and turn it off (no soldering required).
The X, T, and L-shaped 3pin connectors are very safe to use.
Suitable for 10mm wide LED strips. The product is of high quality, high performance and high safety.
For LED tape DIY project compatible with waterproof (IP65 ... IP67) and non-waterproof (IP30) strips
Features:
Applicable to WS2811 WS2812B WS2813 SK6812 SMD 5050 RGB 5V 12V 24V LED strip, 10mm PCB board, no soldering required.
PCB board color: white
Material (connector): PVC plastic
Material (PCB pin): pure copper
PCB type: X T L "X-shaped" from Corss means "shape"
Pin: 3 pins
PCB width: 3pin (10mm)
Installation suggestions:
Open the connector cover and slide the tape.
Make sure the post matches correctly, then hold the lid.
For waterproof strips, the silica gel around the weld line must first be removed.
Installation Notes:
1. Make sure your LED strips have (+) and all contacts are clean
2. Open the white cover of the connector
3. Insert the LED strip into the zipper, under the end - make sure it matches the + and - strips with the + and - closure strips
4. Close the lid
5. Gently pull the LED light bar to confirm that the connection is secure
6. Your contact!
Friendly reminder:
You can't throw
2. Non-waterproof connector
The X, T, and L-shaped 3pin connectors are very safe to use.
Suitable for 10mm wide LED strips. The product is of high quality, high performance and high safety.
For LED tape DIY project compatible with waterproof (IP65 ... IP67) and non-waterproof (IP30) strips
Features:
Applicable to WS2811 WS2812B WS2813 SK6812 SMD 5050 RGB 5V 12V 24V LED strip, 10mm PCB board, no soldering required.
PCB board color: white
Material (connector): PVC plastic
Material (PCB pin): pure copper
PCB type: X T L "X-shaped" from Corss means "shape"
Pin: 3 pins
PCB width: 3pin (10mm)
Installation suggestions:
Open the connector cover and slide the tape.
Make sure the post matches correctly, then hold the lid.
For waterproof strips, the silica gel around the weld line must first be removed.
Installation Notes:
1. Make sure your LED strips have (+) and all contacts are clean
2. Open the white cover of the connector
3. Insert the LED strip into the zipper, under the end - make sure it matches the + and - strips with the + and - closure strips
4. Close the lid
5. Gently pull the LED light bar to confirm that the connection is secure
6. Your contact!
Friendly reminder:
You can't throw
2. Non-waterproof connector
