eBay

Please Read Full Description Before Ordering

These are for Gibson Boards only and will not fit Epiphone pots.

Gibson also used 2 and 3 pin Quick Connects on pickups, which are black and look completely different.

If you are not sure what you have, Please Look inside your guitar before ordering and compare it to the photos.

Photo #2 shows everything that is included.

Attention!!!! The speed of mail shipped from Boston is sometimes unpredictable.

The USPS is still experiencing added delays due to the Covid protocols. The efficiency of your state hub and local USPS plays an important role as well.

95% of the time I ship the envelopes the day you order, but once the mail leaves my possession and into the hands of the post office, I have no control over how long it takes. Thanks

Free USPS economy untracked shipping with other shipping options available at checkout.

(the detailed description starts here)

2 Quick Connect adapters for Gibson (4 conductor+shield) "5 wire" pcb control boards

The wire colors are arranged for the Seymour Duncan Pickup Color Code.

This makes installing Seymour Duncans to Quick Connects much easier. Just match the wires up Color to Color.

The Bare(shield) wire on the pickup goes to the dark blue wire on the Quick Connect.

Check out the diagram in the photos above.

This is the (4 conductor+shield) "5 wire" style Quick Connect that Gibson started using in (around) 2012.

Made from 28 AWG 7 strand tinned copper wire and is about 4 inches long.

Heat shrink tubing for all of the wires is included, as well as 2 larger heat shrink tubes.

The control board in "photo #3" is shown for example and is not included.

If there's ever a problem of any kind, please contact me. I’ll get back to you as soon as I can and I will always fix it and make it right. Thanks

Quick ’n Dirty Tips (always use safety glasses when working with tools)

Even if you have an expensive stripper 😃, sometimes it can still be tricky to remove insulation without a nicking a wire.

When using strippers, just use them to make the cut.

Then pull the insulation off with your fingers.

Don't use the strippers to yank the insulation off!

If you don't have or don't feel like buying wire strippers, here's a couple of alternative stripping methods you might find helpful.

Method 1

Mark a straight line across all 5 wires with a marker

Hold a non serrated butter knife or utility razor blade upside down (or a similar piece of metal) with pliers

Heat the butter knife or non sharp side of the utility razor blade with a lighter or mini/pen torch

Place one wire at a time on a flat surface

Put the hot blade on the marked line of the wire and

Twist the wire under it while pushing the blade forward

There should be a perfect line melted around the insulation now

Pull the little bit of insulation off

You should be good to go

Method 2

Hold the wire in one hand

Run the part of the wire that you want to strip over the flame of a cigarette lighter for 1 second or less (yes, literally 1 second or less)

In a quick manner, pull the piece of insulation right off. It will be a little bit hot.

You should be good to go

Practice these methods on some scrap wire first, then practice on the ends of the quick connect wire.

If you use these alternative stripping methods, it's of your own free will and I'm not responsible for screw ups.