HATERS GONNA HATE Side Stripes

 Dimensions: 
150cm Length X 8cm Height (each side)

The text is cut out of the side stripes
The colour you choose is for the side stripes, the text will show through as the colour of the surface you apply it to

These are designed to be three quarter sized side stripes making them universal for most vehicles


Standard colour is Matt Black

To choose a different colour, send a message after ordering

Colours Available:
Matt: Black, White
Gloss: Black, White, Red, Dark Red, Light Blue, Ocean Blue, Dark Blue,
Yellow, Light Orange,  Orange, Turquoise, Mint Green, Lime Green, Pine Green, Light Pink, Hot Pink, Purple, Silver, Gold, 



Fitting instructions:
Prepare surface properly, ensure it is spotless for best adhesion
Clean only with water: No soaps / cleaning solutions, etc

If fitting on your own, you can use the taped hinge method to fit the design in 2 halves, making it a more manageable size to work with:
To fit the item in 2 halves, offer the graphic up to the vehicle and line up where it is to be fitted, tape vertically across the middle to act as the hinge point.
Tape each end of the graphic too, just to secure the design whilst you step back and check it is lined up correctly.

On one half, lift the clear application tape, removing sticker from the backing paper, remove all the way up to the hinge point and cut away backing paper.
Slowly start laying the vinyl onto the surface, a card will help for best results and minimise trapped air bubbles under the vinyl.
Leave clear application tape over sticker for the moment, then repeat the other half.
 Once both halves have been fitted squeegee over again, then carefully remove the clear application tape.