This 1000 Watt 2 Meter RF Amplifier Board Is made in the USA and includes 1 genuine Ampleon BLF188XR LDMOS Transistor. The transistor used is extremely rugged and can withstand an SWR mismatch for 65:1 or greater at all phase angles. The PC board is professionally fabricated and is designed to produce a very high efficiency(greater then 85%). The amplifier is design for the 2 Meter VHF Band (144 to148MHz) and supports AM, FM, CW, and SSB operating modes. The bias current is preset to 500mA and can be readjusted by use of an independent potentiometer. The board dimensions are 4" wide by 7.5" long. A large aluminum heatsink and forced air are required for proper cooling and for reliable operation. Unit ships with schematic, installation guidelines, detailed parts list, and operating setup instructions. I also provide free technical support by email or phone call.

 Product Description: 2 Meter RF Board

  • 1000 watts RMS Output Power (PEP is higher)
  • Operating Voltage 50 - 56 volts DC
  • Current Draw 25 amps
  • Input power 1.0 – 1.5 watts (depends on the radio)
  • Idle Current 500 mA
  • Operating Class AB
  • Frequency Range 144 to 148MHz
  • Cooling Requirements - Forced air

Watch my video to see the RF Amplifier in operation.

https://www.youtube.com/watch?v=UxdR1KoKc9I&t=265s


Warranty and Repair Policy:


The LDMOS transistors or RF Semiconductors installed in these Module Boards are not covered under warranty. For repairs, Buyer pays shipping costs to ship to seller and return costs to ship back to buyer. Before returning any RF module for repair, please contact the seller to coordinate the return or to request a cost estimate in advance.


Legal Disclaimer:


This LDMOS amplifier is intend for use by suitably Licensed Amateur Radio Operators only and is not intended for Citizens Band (CB) or any other radio services where local and federal regulations prohibit its use. The Buyer assumes full responsibility for compliance with all applicable regulatory agencies and laws.


Legal Wavier:


By purchasing this RF Amplifier you are agreeing to all terms and conditions stated herein. This amplifier used high level of electrical power. Buyer assumes full responsibility for the application and safe use. The Seller assumes no liability for the the use of this product and is not liable for any damage to equipment or personal property. Further, the Seller assumes no liability for personal injury or fatalities that may occur to the buyer or third parties if resold. Buyer agrees to use this product at his or her own risk.


To the maximum extent permitted by law, the seller disclaims (i) any and all liabilities arising out of the application or use of this product, (ii) any and all liability including without limitation special, consequential, or incidental damages and (iii) any and all implies warranties including warranties of fitness for a particular application, pass through warranties if the product is resold, and all non-infringement rights.