eBay

ABOUT US

X8R Ltd is a British company completely dedicated to providing high quality improved design vehicle components; correcting original manufacturers design faults. We take the common faults associated with a variety of vehicle manufacturer’s parts and re-design and manufacture parts that will not fail again or that will prevent damage to vehicles.

Please note that since Brexit (1st January) customs charges are now applicable on all orders going to the EU and these charges are payable by the buyer. Any orders where customs charges are refused are not guaranteed to be refunded.

SYMPTOMS OF FAULT

Water leaking in to the boot. Wet carpets and mats. Rattling / whistling noises, excess wind and road noise.

THE FAULT

c1 aygo 107 boot tailgate seal leaking failure

It is a very common fault for leaks to occur on these vehicles, with water entering and pooling in the boot.

The boot seal on these vehicles are poorly designed from the outset and get worse with age. These on the tailgate sit deep within the mating surfaces on the body of the vehicle. This means a large volume of water can pool above the seals. This overwhelms the seals, entering the back of the seals and causes these leaks.

THE SOLUTION

boot tailgate seal new toyota aygo citroen c1 peugeot 107

Our improved design boot seal is thicker than the OEM, preventing water leaks.

Our replacement boot seal is a direct replacement for the OEM part, this slots in to place as per the original, our seal is improved with a larger diameter to prevent leaks in to the boot.

Our seals are a direct fit and can be fitted in under 20 minutes. Our seals are ready to fit, we also include an alcohol wipe to clean the vehicles body prior to fitting our seals.

Please note that the new boot seal is slightly thicker than the original as it is an improved design. As the tailgate seal is brand new it will have a fair amount of resistance when fitting. If you are struggling to close the tailgate after fitting we recommend using a heat gun or hot hair drier and going around the whole seal ensuring it is fitted as tightly as possible. Then closing the tail gate firmly on the seal to ensure it is fitted as snug as it can be, do this multiple times to start bedding in the new seal.

UK stock

Improvement from OEM design

Next day delivery available

Can be installed in minutes