I made this for my RGV250 as my kickstart vibrated against the frame and wore a horrible mark on it. It came to my attention that a lot of people have this issue and I thought I'ld print a few. It is 3D printed (High Density Infill) from PLA+ plastic for a nice finish and strength. I've got this on my race bike but I haven't been able to put much time on it to say how long it will last but that is why it is printed solid and is designed chunky. It should be a slightly loose fit (so please sand it a bit if your kickstart is thick) and I specifically didn't design it as a clip as this would break over time through flexing, it is more of a guide to stop the arm moving about and hitting the frame. I have also pre-applied the strongest double sided tape I can find so its just peel and stick to install.