Buy with confidence from a long established Australian owned and based company with our 12-month warranty and tax invoice

Hydraulic Power Pack 12VDC 1.6KW or 24Volt DC 2.2 KW Acting 5.0 Lt/Min Max 240 Bar
Special short length unit 2.5 litre tank. Dimensions Length = 36cm x Width = 23cm x Height = 21cm
This double acting solenoid Power Pack has been designed specifically for Double Acting cylinders found on Tail Gate Loaders, Ramps on trucks and trays on low loaders, small cranes or any double acting hydraulic cylinder that is used intermittently.

It is available in both 12 Volt DC or 24 Volt DC. # Please message us preferred voltage. This is a higher quality unit than most offerings on eBay, in that the 'duty' cycle is vastly superior, (see below). DC power uses a lot of current & produces a lot of heat, therefore depending on your usage needs, cheap units will fail quickly.
This unit will produce 5 Lpm @ 3000 psi, but when your load, ie. cylinders are not under full tonnage, it will produce considerably more , meaning your cylinders move faster. 5 Lpm is the Minimum it will achieve. It comes with a two button pendant controller on a 3 mt cable.
Available also in P & T, Single acting, or Double acting
To see 240 volt Powerpack click here.
Two x Double Acting DC Powerpack, click here
Regular Double Acting DC Powerpack, click here
Capable of generating up to 240 Bar (3500 PSI) Pressure.
PLEASE ADVISE US IF MOUNTING POWERPACK VERTICALLY, the oil pick-up will need to be changed out to ensure the oil pumps correctly
This is a quality motor and pump Manufactured in Shanghai to very high standards.

Power Rating 12 (1.6 KW) or 24 DC, 2.2 KW
Amp draw , up to 120 amps
Flow 5.0 litres Minute at 170 Bar (2500 PSI)
Max Pressure up to 240 BAR (3500 PSI)
Pressure relief valve Factory set at 205 BAR (3000 PSI)
Ports 9/16 UNO

2.5 Litre capacity Oil tank with combination breather/level plug and separate fill plug.
Twin Solenoids are mounted to a Steel Valve Block that has spring to centre position with all Ports Closed in centre position.
Four Heavy Duty Solenoid Coils
Manual Actuation or Override on Solenoid Spindles.
LED Indicator Lights on Hirschman Type cable connectors to coils
Flexible Mounting Positions can be mounted Horizontally or Vertically (Motor Up)4 button Control Pendant IP 55 Rated (water and dust resistant) with
5M cable
Safety thermistors installed in motor windings to prevent overheating. Duty Cycle = 25% at Low Duty, low load and pressure (600 PSI) = 100Amps Draw, Allowable run time 12.5 minutes and then allowed to totally cool down. Or 150 seconds ON - 400 seconds OFF.
Duty Cycle = 19% at Medium duty medium load and pressure (1600 PSI) = 160 Amps Draw
Allowable run time 7.5 minutes and then allowed to totally cool down.
or 150 seconds ON - 640 seconds OFF.
Duty Cycle = 7% 300 Amps High Duty High Load and pressure (3000 PSI) = 300 Amps Drag
Allowable run time 1.7 Minutes and then allowed to totally cool downor 150 seconds ON and 2000 seconds OFF.
Dimensions Length = 36cm Width = 23cm Height = 21cmWeight 19 KG

Please click the link below for more Hydraulic Power Packs

https://www.ebay.com.au/str/hydrauliconline/HYDRAULIC-PUMPS-POWER-PACKS/_i.html?store_cat=7426401015