eBay

SHIPPING IS PART OF THE PRICE ON THIS ITEM. SHIPPING IS TRANSPARENTLY CHARGED FOR EACH ITEM PURCHASED FROM THIS LISTING. PLEASE DO NOT CONTACT US REQUESTING FREE SHIPPING.

JL Audio Slash 300/4v3

4-channel car amplifier 300 watts

About the JL Audio Slash 300/4v3

Raw power for your system

The 300/4v3 4-channel amplifier kicks out 75 watts RMS per channel to your speakers. You can also configure this amp to 2-channel mode and run two subwoofers providing 150 watts RMS each. It's patented Class-AB amp circuitry delivers pure, natural sound with very low distortion. The cast aluminum heatsink disperses heat quickly, allowing the amp to run reliably on and on.

Consistent, reliable power

This Slash v3 amplifier is as powerful, as it is smart. Your car system's voltage fluctuates while you drive. The Regulated, Intelligent Power Supply™ system maintains consistent power at any impedance between 1.5 and 4 ohms and at any voltage between 11 and 14.4 volts. You'll get all the power, all the time, even with a range of speaker combinations.

Minimize external noise

With "differential-balanced inputs" to isolate the signal's ground from the chassis ground, it reduces noise making this Slash v3 amplifier compatible with almost any system, including most factory radios. You can adjust the variable infra-sonic- and low-pass filters thus maximizing the performance of your subwoofers.

Features

4-channel car amplifier

Regulated, Intelligent Power Supply system

differential-balanced inputs

75 watts RMS x 4 at 1.5 to 4 ohms

150 watts RMS x 2 at 3 to 8 ohms

Regulated, Intelligent Power Supply system

differential-balanced inputs

variable high- and low-pass filters (50-5000 Hz, 12 or 24 dB/octave)

Absolute Symmetry™ Class-AB amplifier design

MOSFET power and output stages

preamp and speaker-level inputs (speaker-level input requires two optional adapter packs)

wiring and hardware not included with amplifier (4-gauge power and ground leads and a 40-amp fuse recommended)

no onboard fuses — when installing multiple amps in a system, an additional 40-amp in-line fuse between the distribution block and the amplifier is recommended

13-7/16"W x 2-1/4"H x 10"D