30A PWM Electronic Control - Pulse width modulator
30A PWM Electronic Control - Modulator of lar thePWM - Pulse Width Modulator CC
Electronic control
One of the most important and major components to an HHO gas system is PWM (Pulse Width Modulator). This electronic board monitors the electrical pulses flowing throughout the HHO system and adjusts the flow so that the hydrogen gas is controlled.
Usable on any HHO generator,is a pulse width modulator (PWM) to better control the amperage, prevent the system from overheating and producing excess HHO. This unit is based on the Stanley Meyer design and uses a cooling fan to keep the heatsink at the right temperatures.
Usable on any HHO generator, it is a pulse width modulator (PWM) which allows you to:
- check the amperage;
- to the system not to overheat;
- avoid production from Excess HHO.
Pulse Width Modulation, is a method of transmitting information about a series of pulses. PWM, as applicable to HHO control generators, is a way to transmit energy through a succession of pulses, changing the frequency, rather than a continuous (analog) variation of the signal.
It will allow you to control the amperage of the generator in a very easy way. keeps the cell running at optimum operating temperatures and prolongs the life of the cell by increasing the production of HHO
Just connect two wires directly from the PWM30A to the HHO cell and two wires for battery power and two small PWM power wires, the generator is ready to work without any other relays, fuse or devices!
PWM30A it is automatic: it recognizes when the engine is running and only then is the cell activated! When the engine is off, PWM30A turns off the cell (excellent for cars with start and stop device. With the PWM30A you save 1 or 2 hours of installation of the electrical system.
Technical features:
• Blue color
• Compact dimensions: 90X70X24mm
• Auto Power switch sensor motor ON
• 30A MOSFET TO-220 for PWM control
• PWM Trimmer, from 0% to 100% of HHO cell power on
• PWM dimmer status control LED
• Edge and inside the box the power Adjusts Ampere trimmer
• Mosfet startup delay and slow run up Mosfet.
• External custom black aluminum heatsink: 80X20X15mm
• Internal integrated 30A Fuse ~
• 2-way tape barrier for connecting the water tank sensor.
• 4 30A barrier mode MAX strip: +12 / 24 V and GND Battery input, 12/24 V and GND for HHO cell power supply on
• Compact Size, blue transluvìcent plastic box
• Auto Power switch engine sensor ON
• 30A Mosfet TO-220 for PWM control
• PWM Trimmer, from 0% to 100% HHO CELL Power out
• PWM control dimmer status LED
• Onboard and inside the box the Adjust power Ampere trimmer
• Delay startup Mosfet and slow run up Mosfet.
• External black custom aluminum dissipator: 80X20X15mm
• Internal embedded 30A Fuse
• 2 way barrier strip for the connection of the Water Tank sensor.
• 4 way 30A MAX strip barrier: + 12 / 24V and GND Battery Input, + 12 / 24V and GND HHO CELL power out
• Dimensions: 90X70X24mm
