There are some above the mere monster or NPC, these are the final bosses. Dare you confront these?

The special characters available are:
Balur
Gulthor
Mentor
Witch Lord
Grak - Orc Shamen
Ragnar
Wardoz
Zargon
Ragnar Prisoner
Ulag - Orc Warlord (comes with modular morning star and shield, so requires some assembly, compatible replacements with our other HeroQuest Orcs)

Kessandria (Sculpted by The Dragons Dream 3D)

The models listed above are in the complete set.

These characters are printed in resin and are inspired by the original 80's HeroQuest by Monstrous Encounters (excluding Kessandria). 

Available in three sizes:

28mm - Ideal for use with the 80s version of Heroquest

30mm - Ideal for use with the re-release (2021) version of Heroquest, Gloom Haven etc

32mm - For the slightly more imposing size

Bases are supplied separately and require fixing to the models.

Please message us if you would like a specific set of weapons, and hands where modular - we can also mirror the models should you wish. Or would like alternate size bases, such as 32mm Round, or 20mm Square.

They are ideal for any tabletop RPG, such as Pathfinder and Dungeons and Dragons - oh and HeroQuest adventures.

If you have any special requirements (such as a different size, or a mirrored version), please don't hesitate to contact us, and we will see what we can do.

We print each miniature to order, please allow up to 14 days for dispatch, we clean, cure and prepare our minis by hand whilst we endeavour to make sure each is as perfect as can be. However, little evidence of the supports used during printing might still be visible. Models may require some tidying up as you would with any miniature, and can be done so carefully with a sharp craft knife or fine sandpaper. Please take care not breathe in any resin dust, if after cleaning up the model, it is slightly sticky then place in direct sunlight until solid. Make sure you wash your hands afterwards as uncured resin can be an irritant.

Some of the images used in these listings are 3D renders and shown as a presentation of the final print.

Though the resin is pretty strong and resilient, it is not as strong as plastic miniatures. They may break from excessive force such as being dropped.

Please be aware that resin constantly cures when in contact with UV (such as sunlight), this can cause the miniature to become brittle over time, to protect it, you should prime, paint or coat in a UV blocking lacquer or varnish. 

We are a licensed reseller for Monstrous Encounters. You can find out more about their models via their Patreon: 

Monstrousencounters, or store on MyMiniFactory: Monstrous Encounters. If you would like a Monstrous Encounters model printed and we have not listed it, please contact us to see what we can arrange.

Overseas Buyers:

We use the eBay Global Postage System for international deliveries, if you are not located in the UK, we are happy to combine postage for multiple listings. To do this, please add the items to your basket and then select request a total from the basket, if you buy them from the basket, or buy now without requesting a total we cannot combine postage. We will then get notified, we then raise an invoice for the multiple items with combined postage. You will then get the invoice, which you then pay as normal but with the one postage cost. Please contact us if you have any questions.