3D Printed Milwaukee M12 Battery Adapter

This was designed to push onto the top of your Milwaukee M12 battery. The battery and power tap do not lock onto each other, it is the holding force of the spade connection that keeps the tap installed. Be sure to move the assembly by the battery, not the power tap when connected. 

The adapter features about 7 inches of Southwire 16ga stranded wire, which are soldered onto the metal contacts.

NO Battery is included, only the power adapter.

** It is important to take note of your battery charge level. There is no low voltage cutoff on this adapter and it is possible to run the battery level too low. **

These mounts are printed with PETG.

If you have specific requirements, such as different gauge wires, colors, etc, please contact me.