*For International shipping please contact before payment to check the shipping cost to your country*

Q-World Micro Fail Safe For Nitro Car.

Description:

Fail-safe brake setup:

- Connect the fail-safe unit to throttle / break servo and receiver.

- Be sure to observe the polarity of the wire leads.

- Apply full brakes on transmitter and press the set key for two seconds until you see the flashing red light pause.

- Check the function prior to actual operation by turning on the transmitter and moving throttle stick up and / or to brakes position.

- Then turn the transmitter off to insure fail safe has applied brakes.

Status LED :

- Red (Flash) : when transmitter does not receive any interference. (ready to go)

- Red (Solid) : there is radio interference. (Do not run)

- Red (Solid) : Low battery warning. (Do not run)