12V Push Switch ON OFF For Nissan OEM Replacement
*Please measure your mounting hole size (surface of 30mm x 23 mm)
This Switch Suits the following models ONLY
This high quality 12 volt push switch is an ON-OFF switch designed to operate your 12 volt accessories. it has a face surface size of 30 mm x 23 mm and uses the original mounting hole of the vehicle.
Black hard surface rocker, Laser etched Legend
Led: Blue Led
Rated at 3Amp 12V
Wiring cable is included
High quality single pole single throw ON-OFF push switch
Face surface size: 30 mm x 23 mm ( 1.20" x 0.91"), Uses the original mounting hole of the vehicle
These switches are an aftermarket switch that locks into your existing panel super easy to install in less than 10 min's
All symbols are Laser etched directly onto the switch face using modern high Tech laser engraving equipment to ensure long image life.
Wiring Diagram
Green Wire : Connect from your source with an inline fuse
Red Wire-1: Connect to your relay or accessories
Red Wire-2: Normally connected to dash light circuit
Black Wire: Ground