Yaesu FT-1 Extender 4 Board 1 cable Set Riser FT-ONE KIT FORM  (Lower priced alternate set)

Offering a circuit extender board set for use with the Yaesu FT1 transceiver in KIT FORM**. These boards, close in fit and form to the original Yaesu components, are used to extend the lug-in boards so they can be serviced and/or repaired.

Boards are traced, sizes and edge connector are mounted.  Builder needs only to solder the remaining edge connector pins to have functioning extender boards.  About 30 minutes of work is needed to have working extenders.

The jumper cable is fully assembled and ready to use.

The set includes the following boards and jumper cable: 
Two 18 X 2 (18 conductors on each side for a total of 36 conductors) 
One 14 conductor extender single sided extender for 14 conductors. 
One 22 X 2 (22 conductors on each side for a total of 44 conductors) 
One Jumper cable (Original Yaesu part number T9204357)  


TNX & 73 

John    WA1ESO

Official PayPal Seal