Hello! 

Its a SXG Soft Switch True Bypass Guitar Pedal Loop Switch Board only.

Its a board only, no wires, no power supply, no switch

The board will be assembled and I will test it before shipping.

I made this board to use instead of hard pushing 3PDT guitar switch.

You will need +9 to +12V power supply unit, wires and any soft switch (not latching) like push-button switch PBS-24B-4.

Of course you should have soldering skills wiring the board.

Current consumption as low as 3.5mA as I used a bipolar Relay on board.

Voltage stabilizer on board is TSC2950 +5V, MCU - PIC16F15214, Relay - RSM850B6112851005 from Relpol.

Board size: 22mm x 32mm x 10mm

MCU is on a socket for easy reprogramming.

ON: When its turned ON the green LED is ON - the signal goes from the input to the output through a delay circuit, 

board or guitar effect pedal you will connect. Output is affected with a signal effects.

OFF: When the LED is OFF, INPUT IS CONNECTED DIRECTLY TO THE OUTPUT - 

signal flows straight and no any affect to the signal.

I draw a wiring diagram - please look at the pictures.

At every start up board starts from OFF position.

Please write me questions if you have.

Thank you!

Saulius

If you need DRY WET GUITAR MIX BOARD WITH GAIN CONTRLOL AND SOFT SWITCH TRUE BYPASS LOOP SXG:

https://www.ebay.co.uk/itm/225122702126