K1 Relay Switch 10A 30V for Model Aircraft's Smoke Control /Rocket Launch
Description:
l Small size and light weight
l Adopt transparent heat-shrinkable rubber, stylish appearance, at a glance
l Input channels do not need to be calibrated, compatible with various brands of remote control devices
l With boot protection, easy to operate
l Support 5-9v high voltage receivers.
l 1 channel servo signal input, control one way electronic switch
l Maximum 10A30VDC
l Two LEDs indicate working status
l Increased no signal protection
Application range:
l Remote control model rocket launch
l Remote control model smoke control
l Weapon system control like real machine
l Model aircraft's smoke control
l Control of various remote switch systems
l Switch the signals of two cameras
l Control the opening and closing of various electrical power sources, such as navigation lights, searchlights, strobe lights, buzzers, etc.
l Control the camera shutter or switch the camera's recording and camera mode.
Functional Description:
l The remote switch remotely controls the electrical equipment on the aircraft model through a switch channel on the remote control, and the 1-way LED dynamically demonstrates the current switch state in real time, so it can be quickly started without an operation manual.
l This device does not require calibration and can be accurately compatible with remote control devices of various brands.
Typical application:
1. Connect
l Plug the signal input cable into an idle receiver channel (recommended for the two-stage switch channel), which corresponds to a switch on the remote control.
l The red indicator light will be illuminated when connected to the receiver.
l The blue work indicator lights up when the switch channel is open, and vice versa.
2. Working mode
l The red LED is always on; the signal is normal. The red LED light flashes; no signal.
l The blue LED indicates the relay's operating status.
3. Trigger
l Turn the switch on the remote control (OFF->ON), the blue LED lights up and the relay starts to work.
l Turn the switch on the remote control off (ON-> OFF), the blue LED will go out and the relay will not work.
Package:
l 1x K1 Relay Switch
