12V Push Button Switch For Toyota
This high quality 12 volt push switch is an ON-OFF switch designed to operate your 12 volt accessories. it has a face surface size of 39 mm x 21 mm and uses the original mounting hole of the vehicle.
Black hard surface rocker, Laser etched Legend
Led: Blue Led
Rated at 3Amp 12V
Wiring cable is included
High quality single pole single throw ON-OFF push switch
Face surface size: 39 mm x 21 mm ( 1.54" x 0.83"), Uses the original mounting hole of the vehicle
Switch cutout required for the other accessories is about 17mm x 36 mm ( 0.67" x 1.42" )
Upper light is ON when the switch is pressed IN; Lower light can be wired to separate dash light circuit
These switches are an aftermarket switch that locks into your existing panel super easy to install in less than 10 min's
All symbols are Laser etched directly onto the switch face using modern high Tech laser engraving equipment to ensure long image life.
This Switch Suits the following models : Additional vehicles that are not listed may be suitable for these switches. Please Check Sizing
Wiring Diagram
① Green Wire: Connect from your source with an inline fuse
②Red Wire-1: Connect to your replay or accessories
③Red Wire-2: Normally connected to dash light circuit to be ON when your dash lights are ON
④Black Wire: Connect to Ground