4X (Lot of 4) CTS Custom 525K long/split, knurled shaft, audio taper potentiometers. 5% Tolerance (All pots meter between 500K-550K). 

These our own custom branded and spec'd pots manufactured by CTS. These are identical in construction to CTS's high quality 450G series pots, but we spec'd them at 525K. At 5% tolerance all pots will meter between 500K-550K. This means no exceptionally low or high resistance pots that can be found when using a typical 20% tolerance 500K pots. We're very pleased with these pots and think you will be too!

• 525K Ohms - 5% Tolerance (Value can range from 500K to 550K)
• Audio Taper
• Bakelite base plate
• Solid brass c-clip reinforced shaft
• Solid brass bushing
• 3/8-32 US thread
• 3/4" (long shaft) bushing height
• 6mm diameter split, fine 24-tooth knurling
• 1/4" diameter shaft

Each pot comes with hardware - two nuts, dress washer and a lock washer.

It requires 3/8" diameter mounting hole.

This potentiometer is manufactured and branded by CTS specifically for The Art Of Tone (TAOT).

Part # 450S525KXL TAOT.

Notes:

1. If you are uncertain whether your guitar uses short (3/8") or long (3/4") shaft pots, as a general rule this pot will fit most USA-made Gibson Les Paul's manufactured after 1977 excluding historic reissues, but please double check before you order.
2. Make sure to pinch the tip of the shaft before you try fitting a knob, this will avoid getting knobs stuck before you install the pot.