Pre-Cut synthetic leather with a self adhesive back for the Zenza Bronica ETR-C Camera

Leatherette thickness of 0.4mm-0.5mm or approximately 18mil - 8 Color Options - A nice textured material that's very durable.

Before applying - it is very important to remove the old glue / adhesive completely. You CANNOT put this on top of the old glue.

Tips to help with old leatherette and glue removal:

- Heat up the old leatherette a bit using a hair dryer - more of the glue will stay on the old leatherette.

- Use nail polish remover (non-acetone) and a rag and/or q-tips to help scrape off the old glue.

- Patience - sometimes (not always) it will take some time - but it can't be stressed enough how important it is to get the old glue off.

Application tips:

- Make sure everything is at room temperature.

- Removing buttons, levers or memo holders may be needed for proper application.

- One trick you can use is to spread a drop or two of hand sanitizer on the adhesive side - this will allow you to position the leatherette more easily - once the sanitizer evaporates the adhesive gets sticky again.

- Tweezers or something else small will help to push it into the small nooks and crannies.

- Occasionally on tight bends, you may need to add a drop of glue such as contact cement to ensure solid adhesion.

- Once you're sure of the positioning press firmly to get the best adhesion - you may need to keep it pressed down for a minute while you wait for the hand sanitizer to evaporate.

- Please let the camera sit for a couple days after finished - this helps everything to set.

Feel free to contact me if you have any questions or concerns.

Thanks for looking