Banner Multi-Beam SBRXF1-PBAT-LM3, 3- & 4-Wire Scanner Block

SBRXF1 3- & 4-Wire Scanner Block:

Use in place of model SBFX1 (shown below) for long-range opposed fiber optic sensing. Or use where high excess gain is required and it is difficult to run the fibers to both sides of the process from a single scanner block.

• Sensing Mode: Opposed Fiber Optic (Glass Fiber Optics)
• Response: 10ms on/off
• Repeatability: 0.7ms
• Beam: infrared, 880nm

PBAT 3- & 4-wire AC Power Block:

Power block models PBAT and PBBT have an isolated solid-state output switch which may be used to switch either ac or dc. The switch is rated at 100mA maximum, and there is no capacity for inrush. As a result, these power blocks usually should not be used to switch ac inductive loads. However, 100mA is enough capacity to switch many inductive dc loads like small relays and solenoids. Models PBAT and PBBT interface directly to all ac programmable controller inputs.

• Input: 105 to 130V ac, 50/60Hz.
• Output: SPST isolated solid-state switch; 100mA maximum (no inrush capacity), 200V dc max., 140V ac max.
• On-state voltage drop: less than 3 volts at full load.
• Off-state leakage current: less than
• 100 microamps.

LM3 3- & 4-wire Logic Modules:

The LM3 is an on-off logic module that has the ability to be programmed for either LIGHT operate or DARK operate. The LM3 is the most commonly used logic module when no timing function is desired, particularly if it is not known at the time of ordering which mode (LIGHT or DARK operate) will be needed.