NB THIS IS FOR A IMPERIAL  THREAD TYPE. WHITWORTH 

THIS SHAFT HAS WHITWORTH ON THE WET END AND OIL END!!!!!!!!!!!!!!!!!!!!

FOR THE WHITWORTH AND NATIONAL FINE OPTION SEE MY OTHER LISTINGS

For METRIC AND OTHER IMPERIAL see my other listings under the same name


 IF YOU ARE UNSURE OF THREAD TYPES CONTACT ME VIA EBAY or see my you tube channel under the title: "Piston Pump 1 1/2" Metric or imperial parts"

Check out all my videos on overhauling these pumps by checking out my Youtube channel. Channel name is SHEDASAURUS and most videos start with the words -Piston Pump 1 1/2"

Super Kit containing everything you need for a wet end overhaul including brass shaft and oil end gaskets! Kit contains:
1 Brass shaft to suit IMPERIAL WHITWORTH thread BOTH ENDS
2 stainless steel WHITWORTH nuts to suit, One lock nut the other standard
4 IMPERIAL WHITWORTH brass valve screws
1 centre brass washer for buckets (about 3mm thick)
2 Bucket brass washers (over 3mm thick)
4 Valve copper washers- Repurposed Australian 1 penny coins (better than the original)
4 Stainless springs
4 moulded valve rubbers
1 Head gasket (improved design - wider where it counts)
1 Gland gasket
2 side valve gaskets
1 cylinder end gasket
1 40cm length of high speed packing -graphite impregnated teflon
4 oil proof paper gaskets (oil side)
1 valve to use as shaft rubber/ water separator
1 Parts  / exploded diagram
1 rolled pin (used for replacing pin in eccentric- If it ain't broke don't mess with it)

Leave me feed back and I will return the favour 

Posts Australia wide
NB!!!  THIS IS FOR A IMPERIAL WHITWORTH /  WHITWORTH PUMP

CONTACT ME IF YOU ARE NOT SURE

NB unless you specifically ask for the leathers with the 5/8" centre hole I will supply the 3/8" centre hole
To inspect please contact me through ebay

I DO NOT TAKE RESPONSIBILITY FOR YOU CHOOSING THE WRONG KIT -METRIC OR IMPERIAL. IF YOU CHOOSE THE WRONG ONE YOU MUST PAY FOR THE POSTAGE TO RETURN THE INCORRECT PART AND PAY FOR THE POSTAGE TO POST THE CORRECT PART TO YOU