For sale is a resin cast of a sculpted deer skull section (antlers not included!).

Designed to be mounted on a shield (or hanging fixture) and for your own antlers to be attached to it.  

piece will come bone white with a light wash of dark ink in the detail.

supplied with 2 long screws washes and two long bolts (bolts need to be cut to size of your mount)

Item will be pre drilled with a pilot hole for the antlers and I will set 6mm nuts (x2) into the skull so you can bolt the skull to your plaque. This plastic is hard but you need to pre drill any screw holes as the plastic is prone to cracking if screwed in without pre drilling. Also please hand tighten any bolts in pre set nuts as a drill on a high setting might crack the skull.

Holes A are the bolt holes

Holes B are the holes made for the antlers

measurements

Width - 15 cm

Length - 19 cm

Hight - 17cm

Asembly required to be done by buyer.

Perfect for naturaly shed antlers you have found. An ethical display piece for your home.

Fitting for anyones cabinet of curiosity

the last photo in the listing are of the old skull sculpt, just shown to show the mounted antlers.

I have mounted large 40inch fallow dear antlers on this and have a 12 point set of red dear antlers on my own wall which has been up for over 7 years.

Currently I've sold over 40 of these mounts

*PLEASE NOTE*

i have supplied suggested asembly and use. it is down to the buyer to make sure they are mounting and hanging the piece safely. damage of injury because of miss use of the item is not down to me. i supply an item to mount antlers to, hanging is down to the buyer.