ESP32-S3-DevKitM-1-N8 Development Board PCB Antenna ESP32-S3FN8 Chip With 8 MB Flash for Arduino

Description:
1. ESP32-S3-DevKitM-1-N8 is a general-purpose Wi-Fi and Blue-tooth LE combo modules that have a rich set of peripherals. (ESP32-S3-MINI-1 comes with a PCB antenna). (ESP32-S3-MINI-1U comes with an external antenna connector). At the core of the modules is ESP32-S3FN8, a chip equipped with an 8 MB flash. Single USB-to-UART bridge chip provides transfer rates up to 3 Mbps.
2. All available GPIO pins (except for the SPI bus for flash) are broken out to the pin headers on the board for easy interfacing.
3. There are three mutually exclusive ways to provide power to the board: USB-to-UART Port and ESP32-S3 USB Port (either one or both), default power supply (recommended)/ 5V and G (GND) pins/ 3V3 and G (GND) pins. Addressable RGB LED, driven by GPIO8.
4. ESP32-S3-DevKitM-1-N8 is an entry-level development board. Compatible with Windows, Linux, or macOS. Holding down Boot and then pressing Reset initiates Firmware Download mode for downloading firmware through the serial port.

ESP32-S3-DevKitM-1-N8:
At the core of the module is an ESP32-S3FN8, an Xtensa 32-bit LX7 CPU that operates at up to 240 MHz. You can power off the CPU and make use of the low-power co-processor to constantly monitor the peripherals for changes or crossing of thresholds.

ESP32-S3-MINI-1 comes with a PCB antenna. This version is equipped with the ESP32-S3-MINI-1 with 8MB Flash.

It's an ideal choice for a wide variety of application scenarios related to the Internet of Things (IoT), such as embedded systems, smart homes, wearable electronics, etc.

There are three mutually exclusive ways to provide power to the board:
USB-to-UART Port and ESP32-S3 USB Port (either one or both), default power supply (recommended)
5V and G (GND) pins
3v3 and G (GND) pins

ESP32-S3FN8 integrates a rich set of peripherals including SPI, LCD, Camera interface, UART, I2C, I2S, remote control, pulse counter, LED PWM, USB Serial/Jtag, MCPWM, SDIO host, GDMA, TWAI controller (compatible with ISO 11898-1, i.e. CAN Specification 2.0), ADC, touch sensor, temperature sensor, timers, and watchdogs, as well as up to 45 GPIOs. It also includes a full-speed USB 1.1 On-The-Go (OTG) interface to enable USB communication

Most of the I/O pins on the module are broken out to the pin headers on both sides of this board for easy interfacing. Developers can either connect peripherals with jumper wires or mount ESP32-S3-DevKitM-1 on a breadboard.

Package Includes:
1 X ESP32-S3-DevKitM-1-N8 Development Board 

See more in the flyfuntech2022