This 3D printed tablet and stylus holder is designed for the Wacom Intuos line but may fit other tablets. The tablet slot is slightly tapered down to approximately 6.5mm (1/4") thick, 14mm tall, and almost 50mm (2") wide. The overall length is approximately 70mm (2 3/4") and 20mm (3/4") high. Item printed with PLA filament and does not come with a stylus and tablet.
Note: When both the tablet and stylus are in the holder, the stylus is close enough to the tablet that vibrations will activate it. Of course this won't happen if unplugged but if you leave it plugged in and your desk is not sturdy this may become an annoyance if your tablet in Absolute mode instead of Relative. Some Wacom control panels will let you adjust the active distance of the stylus which could help.
Note: Objects 3D printed using Fused Filament Fabrication will have an unusual surface texture and the item you receive may look slightly different than the one pictured. Also, these are printed using biodegradable PLA plastic which has a lower melting point than typical injection molded plastics, so try not to leave it in a hot car under direct sunlight for too long.