6 Gauge Set With Senders 40mph 85mm Gps Speedo Tacho Fuel Temp Volt Oil Pressure
6 Gauge set with senders,40MPH 85MM GPS Speedo,Tacho,Fuel,Temp,Volt,Oil,Fuel sender,Water temp sender,Oil sender
Specification:
Fit For:Car, Truck, Motorcycle , ATV, UTV , Marine
Face Color:Black
Bezel Materials:Stainless Steel
Grade of protection :IP67
Package method :Neutral box
Display Range:40MPH
GPS Speedometer and tachometer:
Operating Voltage:9-32VDC
Install Hole Diameter: 85mm(3-3/8")
This tacho must be hooked up to the "W" terminal on vehicle alternator. Many diesel engines and most inboard gas boat engine alternator have this connection. It can also be working with tachometer sender
Minor gauges:
Install Diameter: 52mm/(2-1/16")
Input Ranges
Oil Pressure: 10~184ohm, 0-145PSI
Fuel Level: 240-33ohm, E-F(If you need other output signals ,like 10-180ohms , 0-90ohms ect, Leave me a note while you paid)
Water Temperature:287.4-22.4ohm,100-250F
Volt: 8-16V
For details, see individual gauge description at link below
Fuel Level:https://www.ebay.co.uk/itm/323175189876
Water Temperature:https://www.ebay.co.uk/itm/222906160349
Volt Meter:https://www.ebay.co.uk/itm/222906170016
Oil Pressure:https://www.ebay.co.uk/itm/323182241929
Sending Units:
Fuel Level Sender:240-33ohms, 6-1/2" (we can DIY the length per your needs, but it will charge you extra funds if you need longer than 6.5inch, Send us a message before you paid)
Attention: A minimum 1"clearance must be maintained between the tank bottom and the float retaining collar in a plastic tank and 1/2"clearance in a rigid metal tank .senders can be used with all gauges brands that have compatible ohms.)
Water Temperature Sender:287.4-22.4ohms,100-250F
Oil Pressure Sender:10~184ohms, 0-145PSI
For other gauge set with senders ,click below:
Speedometer Operation:
1) Press the Set button (less than 1 second) to change the back light color.
Color in sequence : Red(Default)-Green-Blue-White-Yellow-Kelly-Orange-Purple-Auto Mode
Remarks : When users select the AUTO MODE,the backlight will be off for around two seconds,and switch automatically as above sequence per minute.
2) Hold the MODE button for three seconds for Switch TRIP01 or TRIP02 or COG to display.
TRIP 01: (Default) total mileage for one working cycle, data will not be recorded when power off
TRIP 02: total mileage for one working cycle, data will recorded when power off ,but, users could hold the set button for 3~5 seconds to clear
COG 00 : azimuth instantly indicating , data will not be recorded.
Remarks : The unit of trip, total mileage and outta unit of dial are the same .
Speedometer 7 color backlights can be switched backlight as shown below is just an example for your reference
(Tacho ,fuel ,water temp ,volt ,oil pressure ，The backlight color of these 5 watches is red)
