Complete HHO Hydrogen Kit

Dry Cell with 19 316L stainless steel plates

Engines < 2400 cm3

Our generators are manufactured in the European Union, in accordance with the technical standards of industrial production of these products.

Technical data

- Generator type: dry cell;

- Generator dimensions: 110x110x150 mm;

- Dishes: 19;

- Voltage: 12V;

- The standard electrical connections of the cell:

+ NNNNN - NNNNN + NNNNN - (N - neutral plate);

- Hydrogen production: 2.0 liters per minute (25A);

- Optimal power supply: 12-15A.

Kit components:

- HHO Generator - Dry Cell with 19 316L stainless steel plates;

-

-

-

-

-

- Insulated terminals and accessories for all electrical connections;

-

-

-

-

-

-

- Installation manual in Italian (Download Ebook);

Strengths of our products:

Generator Dimensions - The small size of our generators allows for easy installation in all cars. The dry stack can also be installed horizontally or vertically, allowing greater flexibility for installation.

HHO gas production - Despite its performance, the size of the cell is relatively small in proportion to the amount of gas produced which ensures optimal operation over time. The easy reconfiguration of the plates (plus, minus, neutral), from a system of terminals, allows for better optimization according to your needs.

STAINLESS STEEL PLATES - Our plates are made of 316L stainless steel, laser cut, with a special chemical and physical treatment developed by our team to extend the operating life of the generator. You will not see brown deposits in our dry cells. A certificate from the manufacturer guarantees the quality and durability of the stainless steel we use.

Flanges - The new nylon flanges were developed uniquely for our generators. Good physical strength and, above all, thermal resistance (melting point 190-350°C) makes nylon the best material choice for these products. Since the generator will be installed in the engine compartment, where temperatures inside in the summer can be very high, the thermal resistance of the materials used is very important.

Gaskets and sealing rings - Special elastomers made of EPDM rubber (temperature limits of use: -40 to 200 ° C), with a square section and large contact surface. Optimal pressure distribution across the entire sealing surface.

Summary of the strengths of our products

- High quality construction materials ensure a long-lasting product;

- Easy reconfiguration of the plate (positive, negative and neutral) from one terminal system, to optimize the performance of your system;

- Absence of brown deposits in the dry cell and of electrolytes in the circuit;

- Stable generator operating temperatures without risk of overheating

- Insulation of the cell to withstand extreme cold conditions in winter conditions, in order to continue to be effective even in the most severe conditions.