Extra Parts and Dew can be found in this listing
https://www.ebay.com/itm/226064212720
or
https://www.ebay.com/itm/226066245365
The Item for sale:
Color: Matte Black
QTY (1): Light Block Dew Shield ~5.5 Inches (~140mm) fit directly to S50 Telescope (stored/fit on the S50 leg inside the foam case)
QTY (1): Light Block Dew Shield ~5.5 Inches (~140mm) fit with Filter Holder (stored/fit on the S50 leg inside the foam case)
QTY (1): Top/bottom pieces housing Slot Filter Holders for 2" Deep Sky Filters (M48x.75)
QTY (1): Spacer with hole and thread for 1.25-inch Filter (M28.5x.75).
QTY (1): Batinov Mask (fit on the Dew, and fit directly to S50).
QTY (1): Spike Diffraction 4 veins (fit on Dew, and fit directly to S50).
QTY (1): Spike Diffraction 6 veins (fit on Dew, and fit directly to S50).
QTY (1): Len Cap Cover directly fit on the S50 and fit in the off position.
All item is 3D Printed in ELEGOO Matte PLA
(Due to the nature of 3D
print filament it will still shine/gloss after 3D printing the parts in
Matte PLA. But it is way less compared to none Matte PLA)
Remember
that you are screwing into 3D print plastic, so please Counter
Clockwise for the thread to line up, then thread in Clockwise, and not
to over-tighten. Also, it can be used with or without the dew/len
attached.
SeeStar S50Telescope, Len Filter, Case, Paper Clip and Stand not included.
Item will ship in 1 to 2 business days.
Disclaimer:
***NOTE***
Due
to the 3D print nature of this product, your results may vary. Sorry,
there are no returns or exchanges. I am NOT responsible for any damages
to your EAA telescope due to the result of the use of this product
This is the Original
Screw_Threaded Design Slot Filter holder that enables Dew Attachment. So
please beware of other copycat sellers.
***NOTE***