THE PRODUCT IS SUITABLE FOR SMALL TORCHES AND ENGINES
UP TO 5 LT. IT HAS LONG-LASTING THICK SEALS AND ALKALINE CHEMICAL RESISTANT END
PLATES. YOU KNOW: YOU CAN INCREASE YOUR FUEL SAVINGS BY UP TO 35% BY USING
HYDROGEN CELLS. IN SOME CASES EVEN UP TO 50%, BUT THIS DEPENDS ON THE
CHARACTERISTICS OF THE ENGINE. THIS IS A CHEAP SOLUTION FOR PEOPLE WHO WANT TO
SAVE SOME MONEY SINCE ALL KITS ARE MUCH MORE EXPENSIVE. THE PRODUCT IS MADE
FROM THE BEST COMPONENTS THAT ARE RESISTANT TO ALKALINE CHEMICALS. IF YOU ARE NOT
SURE WHICH HYDROGEN CELL YOU SHOULD BUY, YOU CAN CONSULT US. IF THE PRODUCT IS
DAMAGED DURING DELIVERY, YOU CAN REFUND YOUR MONEY OR CHANGE THE PRODUCT FREE
OF CHARGE.
ABOUT THIS PRODUCT:
-21 PCS 316L STAINLESS STEEL PLATE (100X100X0.5mm),
-CELL DIMENSIONS - 105mmX105mmX100mm,
-12 PIECES GALVANIZED PLASTIC COATED BOLTS
-HIGH QUALITY EPDM THICK GASKETS,
-BRUSHED PLATES,
-BEST QUALITY STAINLESS METAL CONNECTORS THAT PREVENT
YOUR ENGINE FROM DAMAGE FROM RUST OR MOLTEN PLASTIC PARTS,
-2 CONNECTOR
-END PLATES MADE OF 10mm THICK ACID-RESISTANT AND
LONG-LASTING HDPE MATERIAL
-PRODUCT READY TO INSTALL YOUR VEHICLE,
-For Engines up to 5 LT
-ALL PLATES LASER CUT,
-MY CELLS ARE MADE OF BETTER QUALITY COMPONENTS THAN
OTHER CELLS ON THE MARKET.
Why this structure:
Stainless Metal connectors: Metal connectors are some of the most expensive connectors on the market,
but they are perfect for hho generators. Metal connectors do not crack and are
not affected by corrosion. Unlike plastic connectors, they do not break in a
short time as a result of heating and cooling of alkaline chemicals.
End plates: HDPE is acid resistant and does not crack. The best choice when it
comes to hho generators. There are also Plexiglas end plates and these are more
likely to crack.
Gaskets: We use acid-resistant gaskets to ensure long-lasting operation. What
we have learned is that EPDM gaskets are great for hho generators. Natural
rubber is not resistant to alkaline chemicals. Don't let them fool you. The
gasket we use is manufactured and certified in the EU. The gaskets we use never
melt or disintegrate.
Why this type of structure: The hho generator will need to be cleaned once a year.
It is possible to clean it in 5 minutes without disassembling the cell with the
method we specified in the user manual. One of the biggest problems experienced
in other four-bolt cells is liquid leakage as a result of the covers bending.
In our 12-bolt cell, the covers never bend because the bolts hold the covers
tightly at equal intervals. When you tighten the bolts to prevent leakage in
cells with 4 bolts, the covers bend even more after a while and leak again.
Working voltage: 12-14 volts
Working current: 0-30 amps
Gas production: 1500ml/min at 30 amps
Pipe connection: 8mm hose