Restore Your Own - Brand New 15 Narrow Center Cut Anti-Static Graphite Resistant Clear Flex-Thin Top Soft CHARCOAL GRAY Foam Pads with a white plastic base + 18 EZ Peel Stick Classic Brown Felt Pads. 5/16" Foam Pads for your 8-track tape restorations. These pads offer a graphite resistant anti-static very slick thin flexible clear top film which helps to resist graphite build-up and has a crisper sound also giving you better contour around your player audio head for great sound and less resistance on the pull going across the audio head and wear on the players motor. These foam pads also contour around your player's track change solenoid offering a great track change while the foam pads top layer gives the audio tape enough resistance to help prevent double or even triple track changes from more sensitive track change solenoids. Because they have a white plastic base just insert them into your cartridge. These foam pads are in the narrow version which are often used on after mid 80's RCA, CRC, mid 70's Elektra and WB late 60's to early 70's GRT or any cartridge that requires a narrow foam pad and will line up evenly with the bottom base's edge inside the foam pad cartridge chamber for a perfect fit. If this foam pad should underlap the bottom edge of the base of the foam pad chamber the 15 count Wide Anti-Static Graphite Resistant Gray Foam Pad with white plastic base + 18 Classic Brown Felt Pads will be needed and will fit evenly with the edge of the cartridge chambers base for a perfect fit.
This item ships out to you USPS First Class Mail due to postal regulations, tracking number will be provided so you will know when to expect your package arrival.
FREE COMBINED SHIPPING Throughout U.S. On Each Additional Foam Pad Purchase During Check-Out!!! For other items purchased other than these foam pads, add each additional item to your cart by pressing add to cart below the Buy It Now Button, the shipping calculator will then automatically adjust the combined shipping cost for all additional items purchased.
Directions For Foam Pads: Remove old original foam pad with long tweezers, only opening the top of the cartridge area first if possible and then inserting the new one after removing the old one, be sure to clean the old foam pad residue left off by the old foam pad with alcohol and a Q-Tip, making sure not to get any inside the cartridge before inserting the new foam pad.
DIRECTIONS FOR FELT PADS: Remove the old, dried glue off the spring pad (if any) by lightly rubbing or scraping it off with an alcohol-soaked Q-Tip or a very small flat head screwdriver. Then apply the EZ Peel & Stick Felt Pad by peeling off the paper behind the felt pad. Then with your tweezers grab a side of the felt pad as close to the edge as possible (try not to grab the adhesive below the felt edge) then line up the felt corners (on the opposite side of where you are holding the felt pad with the tweezers) to the two corners with the metal spring. Then press it down on the metal spring once the two corners of the felt pad and the two corners of the metal spring are all aligned. The adhesive on the peel & stick is very sticky so please be sure to lightly place on copper spring and lightly set till it is square before pressing hard into place.