MTX Audio TR450 Terminator Series 300W RMS 4-Channel A/B Amplifier
The MTX TR450 amp is powerful and very flexible. It can power up 4 speakers (2Ω ~ 8Ω), 2 speakers plus a 4Ω subwoofer on two channels in bridge mode, or two powerful speaker or two subwoofers with its 4 channels in bridge mode.
It shines with its legendary dynamics and exceptional musicality. It has nothing to do with the microscopic amplifiers without switching power supply that equip factory or aftermarket headhunts... In bridged mode, the TR450 can power up a 4Ω subwoofer. Its active x-over allows you to use it for speakers or for subwoofers: 12dB/oct high pass or low pass at 80Hz. It is very simple.
To avoid interference problems, we have equipped the TR450 with balanced inputs. They perfectly isolate the audio ground of the amp so that it does not mix with the noisy ground of the power supply. This is a powerful technique that is usually found on very high end amps. If your car stereo does not have RCA outputs, you can connect the TR450 to the high level inputs. All you need to do is connect the HP cables directly to the high level input of the amplifier. Simple and very practical. If you need it, the MTX EBC-1 remote control is available as an option. It allows you to adjust the level of your subwoofer with a simple analog knob, sitting in the front seat.
Finally, its design and construction are of remarkable quality. Its all-aluminum chassis is the same as that of the prestigious MTX TX6500D and TX81000D amps. We don't skimp on quality at MTX...
- 4-channel Class-AB wide range amplifier
CEA2006 certified power:
- 4x75W RMS @ 2Ω and THD + N ≤1%
- 4x50W RMS @ 4Ω and THD + N ≤1%
- 2x150W RMS bridged @ 4Ω and THD + N ≤1%
Active x-over:
- High Pass (HPF) 12dB/oct @80Hz
- Low Pass (LPF) 12dB/oct @80Hz
- Signal / noise ratio (1 Watt):> 73dB
- THD + Noise (Distortion) (1 Watt): ≤ 0.2%
- Frequency response (± 1dB): 10Hz-60000Hz
- Sensitivity level: 200mV to 6V
- Dimensions: 220x135x52mm
- Low level (RCA) and high-level inputs (speakers)
- Optional EBC remote control (EBC-1)
- Wide range Class-AB amplifier for 2Ω4Ω speakers and subwoofers
- Bridged mode for one 4Ω subwoofer or one 4Ω enclosure
- Optimized for 2Ω in stereo and 4Ω in mono
- Active x-over @80Hz high pass (speakers) or low pass (subwoofers)
- All aluminum construction
- Optimal use with an RTE12AS, RTE12AV, RTF10AS, RTT12AV, TR12AV, RT10AS or RT12AV housing
- Optimal use with TR, TX2 or TX4 loudspeakers
- Optional EBC control (under the reference EBC-1)