USB MIDI Controller with 64 knobs, 2m USB cable
Box dimensions are 290mm x 200 mm x 40mm.
The knobs are potentiometers and are the version that stop
(only turn 270 degrees 7 to 5 o’clock)
Can
be used to control Ableton Live and other DAW software that allows MIDI
learn/mapping and also any device that uses MIDI CC's (please refer to
the manual of your device for the CC numbers).
Each knob can also be set to a different channel allowing control of multiple devices
when used with a DAW only set the controller as an input device and not as an output device
Setting
the CC number
To
set the CC# that a knob/fader controls press and hold the small
button located on the top of the box, the display will show "CC-"
then let go of the button and the display will show 'CC-' then flash the new CC number of that knob/fader,
Example
the cc# number is currently set to 11 - expression and you would like to change it to cc number 74 - frequency cut off (filter) you would hold in the small button on top of the box and move the knob/fader until the display shows number 74, you would then release the small button and the display will show CC- then flash 74 and the cc of that knob/fader is now set to 74.
Tip: If you find it difficult to stop on the exact number, for example you are trying to stop on 10 but it only changes between 9 and 11 go to 30+ then back down and you should be able to stop on 10.
Changing all the knob/fader channel numbers (1-16)
The
channel is changed the same way the cc# is changed but you press the
small button two times and keeping the button held in on the 2rd
press and the display will show “CHA” (channel all) now move any
knob/fader to the number of the channel you want all the faders to be
set to
Then
let go of the small button and the display will show “c” and the
new channel number
Changing the channel of only one knob/fader (channel numbers 1-16)
changing
just one fader/knob channel is done the same way as all the channels
but you press the small button three times and keep the button held
in on the 3rd time and the display will show “CHI”
(channel Independent) now move a knob/fader to the number of the
channel you want that fader/knob to be set to
Then
let go of the small button and the display will show “c” and the
new channel number of only that fader/knob