Description

gipro ATRE G2 Gear Indicator

Instant and accurate indication of the selected gear for added control and safety. The sampling period can be adjusted to make the response quicker or slower, depending on shift speed and signal conditions.

 All settings can be done via the touch sensor so there’s no opening on the housing, it is completely sealed and encapsulated in epoxy. The touch sensitive area is on the TOP of the unit. However, after programming, the unit can be mounted even with the top side stuck to the dashboard (via the sticky pads supplied) and will still work properly. It can also be used along with the optional

gipro Mount without any interference.

 Plug ‘n Go wiring harness, easy to mount display. Complete installation can be done within 30 minutes on most motorcycles.

 Extra bright LED display, housed in a compact box. Available in 5 colors.

 With activated TRE (Timing Retard Eliminator) both throttle response and acceleration are improved in the lower gears. Also, the bike’s top speed limiter is disabled on 1000+ cc bikes. TRE automatically switches off in Neutral for smooth idle operation and switches back to the selected mode when the gearbox is in gear. If a TRE device is installed on a bike equipped with in-dash gear indicator, the bike’s indicator will show the mapped gear. However, the gipro will indicate the gear selected regardless whether the built-in TRE is activated or not. TRE is disabled by default. To comply with local regulations, do not activate TRE mode on

public roads.

 The unit is pre-programmed to fit most motorcycles and it works out of the box. However, if needed, it learns the gear positions automatically, just start the learning function via the menu.

– Full SMT-design, encapsulated in epoxy

– Flash memory to store user settings even with the battery disconnected

– Only inspected, high quality components are built in

– 100% waterproof (IP68)