![]() | Wire bulb. LED, E27, 470lm refill. 40W, amp. incand. white chd, RA90, reg. Brand : Xavax |
- Highly energy efficient bulb with an energy consumption of only 4 W, - High color rendering of Ra90, - Adjustable, - Very minimal energy consumption, - Reduced heat dissipation without UV radiation, - Full and immediate brightness after switching on under voltage, - Simply replaces traditional incandescent bulbs, ,Consumer information:,The LED bulb is designed for operation in open luminaires: the heating of the luminaire during operation can thus be dissipated in the ambient air. The lifespan of the bulb depends on its use. In closed luminaires, due to less cooling, the bulbs last less. Use only in compatible fixtures. Before replacing, the bulb must be cooled and the mains voltage must be cut off. Replace damaged bulbs immediately. No liability will be accepted for incorrect use. ,Certain dimmers can cause bulb malfunctions (flickering, noise). ,Mixed operation, i.e. the simultaneous use of LED bulbs and standard incandescent lamps or LED bulbs of different types in one dimmer is not possible. If noises occur in the dimmer (which did not occur with incandescent lamps): the dimmer is not compatible with LED bulbs. ,Wired dimmers (dimmer built into the power cord) require a separate on/off switch, as they sometimes cannot be adjusted all the way to 0. ,Respect the minimum load of the drive, otherwise it may not start or its setting may be incorrect. Simple dimmers generally operate from 60 W to 400 W. In case of a dimmer integrated with a basic brightness setting, this must be set high enough otherwise the LED bulb may not light up. ,Vary the setting slowly and evenly. Do not proceed in jerks or go too quickly. ,Dimmer for incandescent bulbs allowed only, no dimmer for transformers, etc. ,The touch dimmer is most of the time inappropriate. An unsuitable dimmer can irreparably damage the bulb. |