Extra Parts and Longer Dew can be found in this listing https://www.ebay.com/itm/226064212720
The Item for sale:
Color: Matte Black
QTY (1): Top/bottom pieces housing Slot Filter Holders for 2" Deep Sky Filters (M48x.75)
QTY (1): Spacer with hole and thread for 1.25-inch Filter (M28.5x.75).
QTY (1): Light Block (Dew) about ~4 inches (~101mm) in height (Can be stored/fit on the S50 leg inside the foam case)
QTY (1): Batinov Mask (inner diameter fit on the light block (Dew), and the outer diameter fit directly to S50).
QTY (1): Spike Diffraction 4 veins (inner diameter fit on the light block (Dew), and the outer diameter fit directly to S50).
QTY (1): Spike Diffraction 6 veins (inner diameter fit on the light block (Dew), and the outer diameter fit directly to S50).
QTY (1): Len Cap Cover directly fit on the S50 and fit in the off position.

All item is 3D Printed in ELEGOO Matte PLA (Due to the nature of 3D print filament it will still shine/gloss after 3D printing the parts in Matte PLA. But it is way less compared to none Matte PLA)

Remember that you are screwing into 3D print plastic, so please Counter Clockwise for the thread to line up, then thread in Clockwise, and not to over-tighten. Also, it can be used with or without the dew/len attached.

SeeStar S50Telescope, Len Filter,  Case, Paper Clip and Stand not included.

Item will ship in 1 to 2 business days.

Disclaimer:

***NOTE***
Due to the 3D print nature of this product, your results may vary. Sorry, there are no returns or exchanges. I am NOT responsible for any damages to your EAA telescope due to the result of the use of this product

The original Combo Listing sale was for a Dew length of ~70mm, but a lot of buyers want the Dew length to be longer so from 5/14/2024 the Dew length will be ~101mm (~4 inches).

This is the Original Screw_Threaded Design Slot Filter holder that enables Dew Attachment. So please beware of other copycat sellers.
***NOTE***