Universal NiCd, NiMH, LiIon powertool battery charger base for 7.2V-20V* batteries (Adaptor plates required. Sold separately).
Features:
- Input: 100-240VAC, 50-60Hz, 1.2A, 70W
- Output:
- 7.2V-20VDC 1-3A. Please see note below re 20V batteries.
- 2 x 5V 2.1A max. USB output.
- Interchangeable adaptor plates (sold separately) to charge a variety of powertool batteries from different brands. See below to view the range of adaptor plates.
- Supplied with 1100mm SAA approved 100-240VAC world voltage input power cable.
- Short circuit protection.
- Reverse polarity protection.
- Over temperature protection.
- Max 2.5 hour charging limit protection.
- Low voltage slow charge safety protection.
- LED status indicators:
- GREEN = Ready / Charge complete
- RED = Charging
- Flashing RED = Error
- Dual USB output ports to charge portable devices from phones to tablets.
SBSD stocks the grey ACMT charger base as standard. Other colours are available upon request. MOQs apply.
*Previous green model replaced with grey model July 2019
*Note: Due to variations in manufacturer labelling guidelines, some batteries may be labeled as 18V or 20V. In both cases, the battery pack contains five LiIon cells in series, hence 5 x 3.6V (or 3.7V depending on the cell used) equates to an 18V-18.5V battery pack. Therefore, a battery pack labeled as 20V wil typically have a nomial voltage of 18V and will still be compatible with this charger, provided the correct adaptor plate is used.