59" 3D Carbon Fiber Car Rear Wings Spoiler Lip Tail Trunk Boot Roof Trim Set
100% High quality and brand new
3D Carbon fiber style
Fitment: for most cars,trucks,SUVs
Material:High quality black carbon fiber rubber with 3M adhesive
Size: approx 150cm(length) x 3.5cm(width)
Position: Car Spoiler/Roof/Hatch Gate/Trunk/Bonnet ect...
Feature:
Flexible and lightweight foam rubber install in minutes using ultra strong automotive tale(PRE-APPLIED).
Gives your ride a more aggressive and customized look.
Professional installation is highly recommend.
No special too, no drilling or screws required.
High performance ,racing style.
Flexible enough to conform to different applications.
Helpful Tips:
Clean the trunk and remove any dirt or leftover water. This will ensure a strong bond with the bumper
Peel the backing off of one end of the lip. Position the tape so that the lip is protruding towards you.Make sure to press firmly.
Continue to peel and attached to the rest of the trunk making sure the lip is even as you do.
Cut off the excess with scissors.
Note:
Do not touch water after pasting within 48 hours.
Size: approx 150cm(length) x 3.5cm(width)
Position: Car Spoiler/Roof/Hatch Gate/Trunk/Bonnet ect...
Feature:
Flexible and lightweight foam rubber install in minutes using ultra strong automotive tale(PRE-APPLIED).
Gives your ride a more aggressive and customized look.
Professional installation is highly recommend.
No special too, no drilling or screws required.
High performance ,racing style.
Flexible enough to conform to different applications.
Helpful Tips:
Clean the trunk and remove any dirt or leftover water. This will ensure a strong bond with the bumper
Peel the backing off of one end of the lip. Position the tape so that the lip is protruding towards you.Make sure to press firmly.
Continue to peel and attached to the rest of the trunk making sure the lip is even as you do.
Cut off the excess with scissors.
Note:
Do not touch water after pasting within 48 hours.
Adhesiveness is weaker when the temperature below 20 degrees, use with heat gun to heat the thermal double-sided adhesive will be better.
Package: 1pcs
