Introduction:
A dim, cloudy, yellowed, or otherwise damaged or non-functioning headlight makes
A dim, cloudy, yellowed, or otherwise damaged or non-functioning headlight makes
driving dangerous,not only is your own safety at risk, but the safety of others is as well.
But our new pair of headlight not only will allow you to see the road clearly during the night
and in any bad weather that may arise, and let you see road markings and traffic signs better,
gives you and your family a safer nighttime driving, but also will makes your truck looks more
charming and attractive, take your truck on an altogether new aspect.
Application:
Fit for 2007 - 2013 GMC Sierra 1500
Fit for 2007 - 2014 GMC Sierra 2500 HD
Fit for 2007 - 2014 GMC Sierra 3500 HD
Does NOT Fit 2007 (Old Body Style) Classic Models
Does NOT Fit 2014 (New Body Style) Sierra 1500 Models
Specification:
Pattern: Chrome Housing Clear Lens with Amber Reflector
Material: High grade ABS plastic, for toughness, impact resistance, and heat resistance.
High Quality: Fully sealed, waterproof, dust and corrosion resistant, works perfectly even
in harsh weather conditions.
Plug & Play Installation: Fully compatible as replacement for factory parts.
High Beam: 9005 / HB3 (Bulbs Not Included)
Low Beam: H11 (Bulbs Not Included)
Turn Signal Light: 3157A (Bulbs Not Included)
Package Included:
1 Pair of Headlights (Left & Right) (Bulbs are not included)
Warm Tips (How to install):
1. Undo the screws, clips, or retainer springs that hold the headlight in place.
2. Disconnect the wiring from the assembly.
3. Detach the headlight from the vehicle to replace it with a new one.
4. Fit in the new headlight assembly.
5. Fix the new headlight into place and make sure that the screws, clips, or retainer springs
1. Undo the screws, clips, or retainer springs that hold the headlight in place.
2. Disconnect the wiring from the assembly.
3. Detach the headlight from the vehicle to replace it with a new one.
4. Fit in the new headlight assembly.
5. Fix the new headlight into place and make sure that the screws, clips, or retainer springs
used are sealed.
6. Reconnect the wiring that was unplugged from the assembly.
7. Put back the grille and other components that you removed. Seal them back into place.
8. Test the new assembly.
6. Reconnect the wiring that was unplugged from the assembly.
7. Put back the grille and other components that you removed. Seal them back into place.
8. Test the new assembly.