1 Set Contents Below:

Acid

Parallel Sleeves φ1.8 φ2.0

Parallel Pins

φ1.8 Short/Long

φ2.0 Short/Long

 

Attachment drill aid for parallel implantation.

Four guid – pins and three drill – sleeves make surgery

better and shorter.

You can easily make a hole for parallel implantation.

Pilot drill (dia 1.8 to 2.0mm) is available.

All parts are autoclavable.

Advantages: 

1. Parallel planting arrangement;

2. Simple operation to achieve good prosthetic effect;

3. Can be directly disinfected;

4. Suitable for any implant system;

5. Reduce surgical time. 

 

 

 

Attention: 

1. There are two specifications of guide rods, S and L, with a diameter of 1.9mm. It can be swapped up and down to meet the needs of different positions on the left and right.

2. The minimum distance that can be reached between the guide rod and the drilling hole is 6mm, and the maximum distance is 88mm.

3. The drilling design is suitable for 2.0mm drill bits. 

 

1. Parallel implant assistive device is a simple device that can ensure parallel implantation without affecting the surgical process.

2. The parallel planting assistant includes a guide arm and a drilling arm. The two arms are connected, allowing the guide arm and drilling arm to move parallel and freely. The design of the drilling arm is suitable for 2 0mm drill bit. 

 

Surgical process: 

1. Mark the planting site;

2. Drill holes on the jawbone using a guided drill bit to ensure the ideal axial direction;

3. Insert the guide rod into the bone hole drilled by the guide drill bit;

4. Use parallel planting aids for parallel drilling of other bone holes. If necessary, the guide rod can be changed to the other side of the guide arm, so that it can be interchanged left and right;

5. Finally, prepare the bone cavity according to different implant systems. 

 

Advantages: 

1. Parallel planting arrangement;

2. Simple operation to achieve good prosthetic effect;

3. Can be directly disinfected;

4. Suitable for any implant system;

5. Reduce surgical time. 

 

Attention: 

1. There are two specifications of guide rods, S and L, with a diameter of 1.9mm. It can be swapped up and down to meet the needs of different positions on the left and right.

2. The minimum distance that can be reached between the guide rod and the drilling hole is 6mm, and the maximum distance is 88mm.

3. The drilling design is suitable for 2.0mm drill bits.