NOTE ON PICS,
I have both the longer 200mm/8" connector lead and shorter 4" lead fuse boxes in stock
I am selling the longer 8" lead in this listing,
I am selling the longer 8" lead in this listing,
but you can request whatever length you want, just message me.
also see: ebay item # 224662416994
also see: ebay item # 224662416994
Comes with three 10A and one 20A fuse installed
- if these don't match the stock system just swap them out.
8 Pin female terminal connector installed
1 Male 8 Pin terminal connector
8 Male spade terminals
Wire colors: 2 red, 2 red/yellow line, 2 brown, 2 red/white line
Mounting holes = 94mm (3.7") measured center to center
Box dimensions = 3 1/8" x 2 3/8" x 3/4" (excluding mounting points)
8 Pin female terminal connector installed
1 Male 8 Pin terminal connector
8 Male spade terminals
Wire colors: 2 red, 2 red/yellow line, 2 brown, 2 red/white line
Mounting holes = 94mm (3.7") measured center to center
Box dimensions = 3 1/8" x 2 3/8" x 3/4" (excluding mounting points)
Fits Yamaha: (splicing in to stock wiring is required)
XS360C/D - 1976-1977
RD400C/D/E - 1976-1978
XS400D/E/F/SG/SH - 1977-1981
XS400J/RJ/K/RK - 1982-1983
XJ550H/RH/RJ/RK - 1981-1983
XS500B/C/D - 1975-1977
FZ600/S/U - 1986-1988
XS650D/SE/2F/SF/G/SG/H/SH/SJ/SK - 1977-1983
XJ650/G/H/LH/J/LJ/RJ/K/LK - 1980-1983
XJ750J/K/MK - 1982-1983
XS750D/2D/E/SE/SE-31/F/SF - 1977-1979
XS850G/LG/SG/H/LH/SH - 1980
XJ1100J - 1982
XS1100E/F/G/LG/SG/H/LH/SH - 1978-1981
FITS These XS models nicely:
- Yamaha XS1100 1978 - 1981
- Yamaha XS1100 Venturer 1981
- Yamaha XS1100L Midnight Special 1980 - 1981
- Yamaha XS1100S Special 1979 - 1981
- Yamaha XS650 1975 - 1981
- Yamaha XS650 Twin 1976
- Yamaha XS650S Heritage 1982
- Yamaha XS650S Heritage Special 1983
- Yamaha XS650S Special 1978 - 1983
- Yamaha XS650S2 Special II 1979
- Yamaha XS750 1977 - 1979
- Yamaha XS750-2 Triple 1977
- Yamaha XS750S 1978 - 1979
- Yamaha XS850 1980
- Yamaha XS850 Venturer 1981
- Yamaha XS850L Midnight Special 1980 - 1981
- Yamaha XS850S Special 1980 - 1981
I also carry XJ650/700/750 fuse box:
Item ID: 234256392263
This is great! Looks stock, enhances value!
Specifically designed for Yamaha XS and XJ & FZ600 series bikes:
I love to use them on my XS1100 projects, XS650, XS750/XS850,
XJ Maxims/Secas, early FZ's and other models!
The XS Fuse Boxes located on top of the battery,
or under the side panel, are a part of the original wiring harness,
- and until now, have Not been available separately.
This is a replica of that box as shown, plus matching terminal block & terminals.
None of the stock YAMAHA fuse boxes come removable from the factory.
This comes with all the terminals and connectors to splice into your wiring harness.
With the addition of the connector block, if you have problems down the line,
(in say, another 30-40 years), you can easily remove the whole box,
because you have already installed the quick snap connector!
Simply cut the old fuse box from your main harness,
(noting which wires go to which fuse circuit! :-), I like to go one at a time...lol
Install the supplied terminals, then attach the connector block (provided)
and plug in the new fuse box!
Includes 1 x 20Amp and 3 x 10Amp fuses.
And of course, you can substitute any amp fuse,
in any slot, as needed for your particular bike / circuit.
-------------------------------------------------------------------------------------------
recommended tools are: wire strippers and a crimping tool
*ask one of your buddies,
- someone is bound to have some crimpers you can borrow! lol :-)
* note: For better than Factory, professional results, the male connectors for the plug
____________________________________________________________________________
*ask one of your buddies,
- someone is bound to have some crimpers you can borrow! lol :-)
* note: For better than Factory, professional results, the male connectors for the plug
should be soldered in place, once crimped to the wires. this eliminates pullout. *
____________________________________________________________________________
Shown below is a picture of the fuse box and connectors,
and above that is a battery cover intended for XS650 models
you can use this for any 4 fuse setup.
cut your old one out of the harness, and install the supplied terminals,
matching the wiring positions with your old fuse box.
and above that is a battery cover intended for XS650 models
you can use this for any 4 fuse setup.
cut your old one out of the harness, and install the supplied terminals,
matching the wiring positions with your old fuse box.
Here is a tip: ride the bike for 5 or 10 minutes and
put you hand close to the fuses, touch them all quickly to
see if they are warm or hot to the touch.
If they are, there is resistance, usually the clips themselves are the culprit.
trying to clean them with say, a dremel wire wheel, will often just break them,
because the heat has made them so brittle.
I recommend replacing them all, and checking again for heat.
I suggest that all the connectors on the bike, especially charging system
and the ignition wires that go inside the headlight bucket, should be cleaned,
de-oxified, and packed with dielectric grease
NOTE: THE LARGE BATTERY COVER
(Shown at the top of the pic ~ below) IS NOT INCLUDED!
You can buy this cover- @ a very low price, only $4.00
i will add it to your order if you want it and combine shipping.
------------------------------------------------------------------------------------------------------
ACTUAL EBAY FEEDBACK:
Just as described...Thank you. Could not be any happier.
(Shown at the top of the pic ~ below) IS NOT INCLUDED!
You can buy this cover- @ a very low price, only $4.00
i will add it to your order if you want it and combine shipping.
------------------------------------------------------------------------------------------------------
ACTUAL EBAY FEEDBACK:
Perfect swap out for my Maxim and my wife's Seca. No problems since I put them in.
Buyer: alra_6705 (1)
Yamaha XS XJ RD RZ FZ600 TX XS650 XS1100 Fuse Box replacement OEM 4 Glass fuse
Just as described...Thank you. Could not be any happier.
| Buyer: | ||
| Yamaha XS XJ RD RZ FZ600 TX XS650 XS1100 Fuse Box replacement OEM 4 Glass |
| Item as described. Would definitely shop with this seller again. | Buyer: | |
| Yamaha XS XJ RD RZ FZ600 TX XS650 XS1100 Fuse Box |
| Great ebayer#1 !!!!!!!!! | Buyer: | |
| Yamaha XS XJ RD FZ XS650 XS1100 Fuse Box replacement OEM 4 Glass fuse |
| Thanks!!!!!!!!!!!! | Buyer: | |
| Yamaha XS XJ RD FZ XS650 XS1100 Fuse Box replacement ( |
| REALLY COOL JUST WHAT I NEEDED.5 STARS AND THANKS MUCH! | Buyer: | |
| Yamaha XS XJ RD FZ XS650 XS1100 Fuse Box replacemen |
| Product as advertised. Worked great! | Buyer: | |
| Yamaha XS XJ RD FZ XS650 XS1100 Fuse Box replacement |
| great e-bayer A++++ | Buyer: | |
| Yamaha XS XJ RD FZ XS650 XS1100 Fuse Box replacement |
| This thing is a drop in and works GREAT! Thanks for having it, A++ Dealer | Buyer: | 6 |
| Yamaha XS XJ RD FZ XS650 XS1100 Fuse Box replacement |
Contact me with any problems.
Please contact me before leaving neutral or negative feedback!
I have a 100% feedback rating !
as always, ask questions first before buying!
Please contact me before leaving neutral or negative feedback!
I have a 100% feedback rating !
as always, ask questions first before buying!