W2ENY HiFi MIC ELEMENT
My custom design modernizes your old
Astatic D-104 Silver "K" Eagle or Night "K" Eagle
I've been experimenting with MANY headsets over the last years, I had previously used a Heil headset til now. This wide range electret element far exceeds mic specs for optimum use of todays technology.
I designed this application for a direct solder in replacement that brings Hi-Fi audio and new life to my old amplified D-104 (must have amplifier and 9v battery in the Night Eagle stand). Upgrade your old classic and get good audio reports!!!
It's a 10 minute job to replace and it works great!! Features great sound with full range audio, I've been getting nothing but excellent 'ON AIR' audio reports ("Sounds just like you, Bob!").
50 Hz - 16 kHz wide range FLAT Response - Natural Sound
Finally, a way to upgrade from that shrill, top end sound offered by similar crystal replacements!
This listing is only for the "W2ENY HIFI D-104 Night Eagle Replacement" kit with short tinned leads, resistor jumper and new black felt shown in the pic - all else in the pic is shown for illustration only.
Electret Mic element, resistor/jumper, black felt and instructions are included.
This replacement is ONLY for the Silver/Night "K Eagle D-104, green ETS amplifier board and battery - PLEASE SEE PICS.
The Silver and Night Eagle used two different boards, this will NOT work with the one labeled PC100 (see my other listing for TUP9 then.
Thanks for looking!
Basics on how it's done, install pictures come with your purchase:
Disassemble the microphone head – four screws.
Insert the mic/felt assembly supplied behind the front screen.
Solder leads from the neck to the mic as in the instructions.
Insert some foam to hold the element in place Remove bottom cover plate.
Add resistor jumper assembly as shown in the instructions.
Reassemble.
Done.
NOTE to ebay: W2ENY is my brand, this is not a duplicate listing as it is for a specific configuration for a specific radio.
|