Product Description:
New Hejnar Photo conversion set for Manfrotto MHXPRO-3W 3-Way Pan/tilt head. This combination of plate and clamp will let you use Manfrotto head with any arca swiss equipment. Clamp can disconnected from plate and use independent on other equipment if needed. Clamp can be positioned in relation to adapter plate in 90 degree increments to make it convenient for everybody. It is the best quick release system for tripods and monopods. International standard dove-tail clamp, compatible with Arca-Swiss type quick release plates
I would suggest to purchase gear head before placing order for adapter plate and compare maunting pattern with your head. I also have similar setup for 405 gear head in my store if your need one.
Please check mounting hole location before placing order. See picture for references.
Adapter plate is attached to Manfrotto geared head in a few simple steps.
Detail instruction can be fund here
Compatible with:
Specification:
- 2.375 inch long
- Socket is countersunk on top for 1/4-20 screw but also threaded 3⁄8”-16.
- Two set of outside holes are taped 1/4-20 and 30 mm apart from each other.
- Clamp includes two safety stop relief grooves. This prevents free fall when the clamp is not fully closed and your plate has safety stops
- Clamp knob is captive. Knob stops at maximum opening — cannot be lost in the field.
- Clamp knob is made from one piece. No spacers or bushing between knob and clamp itself. No room for dust, sand etc to enter inside.
- Made from 6061-T6 Aluminum.
- Black hard coat anodized clamp and clear anodized knob.
- Made in USA
Auction Includes:
- One adapter plate.
- One 2.375 inch clamp ( Model F62b)
- One 1/4-20 x 3/4 flat head screw.
- One 1/4-20 x 7/8 flat head screw
- One 1/4-20 x 3/4 button screw
- Two 10-32 screws
- Hex key for ¼-20 screw 10-32 screw and original level screw